Vinyl Installation Guide

Before you start

Clean and dry the surface thoroughly. Work in a clean, sheltered area and ensure the film and surface are at a suitable application temperature. A heat gun is required for installation; use gentle, controlled heat and avoid overheating the film or the surface.

Applying vinyl wrap

  1. Measure and cut with extra material around the edges.
  2. Position the film and apply gradually using a felt-edge squeegee, working from the centre outwards.
  3. Air-release vinyl wrap is generally best applied dry, especially on curved surfaces. Wet application is possible on flat surfaces, such as sun-strips. Remove as much water as possible with a squeegee and allow 24–48 hours for the vinyl to adhere correctly.
  4. Gently warm curved areas to help the film conform, without overstretching.
  5. Where a film has a clear protective top layer, remove it after fitting.
  6. Check edges and corners for secure adhesion.

Window and headlight films

Follow the installation instructions supplied with your order. Wet application may be suitable for specified films and flat surfaces; remove all application fluid with a squeegee. A heat gun is required for installation. Do not apply film to hot lamps or damaged surfaces. Check applicable road-use rules before tinting vehicle lights or windows.

Always test a small area first. If you are unsure which method is suitable for your film, contact VT Supplies before installation.