Matt Forged Carbon Fibre Vinyl Wrap

Matt Forged Carbon Fibre Vinyl Wrap

A5 sample / 1 sheet
£5.99
Skip to product information
Matt Forged Carbon Fibre Vinyl Wrap

Matt Forged Carbon Fibre Vinyl Wrap

£5.99
Width
Length

View store information

Matt Forged Carbon Fibre Vinyl Wrap

A5 sample / 1 sheet

Give your next wrapping project a matt forged carbon fibre-effect finish with VT Supplies Matt Forged Carbon Fibre Vinyl Wrap. Made from premium calendared vinyl, this self-adhesive film is suitable for styling vehicle body panels, bonnets, roofs, mirrors, interior trim and motorcycle panels on appropriately prepared smooth surfaces.

Product features

  • Matt forged carbon fibre-effect finish.
  • Premium calendared vinyl for a refined appearance.
  • Triple-layer construction with a removable clear protective top layer.
  • Suitable for wrapping appropriately prepared smooth surfaces.
  • Self-adhesive backing with air-release channels to help work trapped air out during fitting.
  • Heat-assisted fitting to help shape the film around suitable curves; avoid excessive stretching.
  • Cut to your selected width and length and supplied as one continuous piece.

Important — matt finish: This is a triple-layer vinyl. The clear protective film on the surface has a glossy appearance, so the wrap may initially look gloss rather than matt. This is only the protective layer. Once installation is complete, peel off the clear top layer to reveal the true matt forged carbon fibre finish.

Choose your roll size

Available widths: 15cm, 30cm, 50cm, 75cm and 152cm. Available lengths: 2m, 3m, 4m, 5m, 6m, 7m, 8m and 9m, plus 18m full-roll options in selected widths. The 152cm width is available in lengths from 2m to 8m only. Select the size you need from the product options. Measure carefully and allow extra material for trimming, edges and curves.

Fitting advice

Apply in a warm, clean environment to a smooth, dry surface free from dust, grease and wax. Ensure any painted surface is sound and fully cured, and test a small inconspicuous area first.

Dry application is recommended for the air-release adhesive. Work gradually, peeling away the backing paper while smoothing the vinyl with a felt-edged squeegee from the centre outwards. Use gentle, controlled heat where needed to help conform to curves; do not overheat or overstretch the film. Leave the clear protective top layer in place during application, then remove it once fitted to reveal the matt finish.

Ordering and delivery

Each selected roll size is supplied as one continuous piece. Delivery arrangements and any additional charges for long or full-width rolls depend on the delivery address; please check the shipping information at checkout or contact VT Supplies before ordering if you need a specific service.

A4 sheet options include 1 sheet (210 × 297mm) at £6.99, plus the existing 5-sheet and 10-sheet packs.

Installation requirements

A heat gun is required for installation. An installation guide is provided with every order.

You may also like